Price: $79.66
List Price: $99.00 - Savings: $19.34
(10-99 $69.88)
Description:
Aquamatic by Marey electric shower water heaters are installed directly on the shower water pipe. These heaters are commonly used where central hot water is not available. Never run out of hot water. Ideal for countries with warm climate.
Our most innovative electric shower heater design. Includes two temperature options and cover. It also comes in 110v and 220v power (Defaults to 110v unit unless 220v is selected at checkout)
Works great with any water pressure.
Save water and Energy . Uses less energy and less water than any other shower heater in the market.
How it Works:
When the unit senses water flowing, the electric circuit is activated and the water is heated instantly. It is 100% automated, as soon you turn off the water flow the heater turns off. Water temperature is regulated with water pressure. Less water pressure more heat, more water pressure, less heat.
2 Temperature Settings (Low and High) for warm regions where hotter water is not needed during certain seasons. Remember, the Aquamatic II has limited heating capabilities and should be used when incoming water temperature is 60F degrees or higher. NOT INTENDED FOR COLD REGIONS.
Common Uses:
House or apartment Pool side hot shower rinse offs Cabins Campers Trailers Boats and more
MSRP: $99.00
SPECIFICATIONS
Technical Data:
Volts Temperature Position Watts Amps
110V II 3000 24 110 V I 1760 16 220V II 4000 19.4 220V I 2750 12.6
Minimum water pressure: .83 GPM Maximum water temperature increase: 25 º F or 13º C Maximum water flow: 2 GPM
30 AMP breaker required Minimum water pressure: .83 GPM Average water temperature increase: 10 – 25 º F Maximum water flow: 2 GPM
White ABS Plastic Casing
6' HEAVY DUTY PRONGED CORD (INCLUDED)
(220V unit available upon request- 110V unit will be shipped by default)
Installation:
30 Amps circuit breaker for the exclusive use of the heater. No special piping needed. So easy to install, anyone can do it. Just unscrew your old shower head. Screw a straight nipple and the heater with teflon tape and plug the heater into the wall plug (six feet away from the shower area).
Other installation details:
Install on copper or galvanized metal pipes Do not use extension cords
IMPORTANT: WHEN INSTALLING THIS HEATER FOR THE FIRST USE - YOU MUST RUN WATER THROUGH THE HEATER FOR 10 SECONDS BEFORE YOU APPLY POWER FOR THE FIRST USE.
Sign In
